Weather resistant premixed key coat for AAC surfaces
Spatter Dash LB a cement based coat composed of hydraulic binders, selected aggregates, and high performance additives. It is supplied as a dry powder in pre-weighed bags ready to use on site, which requires only addition of clean water to produce easily workable mortar. Spatter Dash LB is a high quality product for multipurpose applications such as scratch coat on highly absorbing surfaces and ceilings such as AAC, thermalite & calcium silicate.
Spatter Dash LB supplied in 50 Kg Bag or Bulk. Yield - 1.8 Kg / m2 /mm thickness
Original sealed container of Spatter Dash LB has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 25ºC.
Add to the mixing container 9.5-11.5 liters of water for each 50 Kg bag of Spatter Dash LB. Add the powder to the water and mix with a mechanical plaster mixer or low speed electric drill fitted with a suitable paddle for 3-4 minutes, until a uniform, lump-free consistency is achieved.
Manual mixing is allowed for small batch quantities and mix for approx. 1-2 min or when homogeneous mix is achieved.
Spatter Dash LB preferably be applied in a single coat application to achieved desired thickness of 4-6 mm.
Apply mixed material using mechanical spray or manual spatter machine or hawk & trowel technique.
Cover 95-100% of surface area to be plastered.
Allow the installed application to remain undisturbed for at least 48 hours.
Spatter Dash LB is best cured by spraying water on the surfaces of applied materials every 12 hrs for minimum of 3 days. During hot & dry conditions allow curing for minimum of 5 days. It will help to obtain high mechanical strengths and minimize the risk of surface cracks.
Substrate should be sound, clean, free from loose material, grease, laitence, dirt curing compound, or any other substance that might impair the quality of bond with the substrate. Prior to Spatter Dash LB SDL211 Application, soak the entire surfaces with clean potable water. The substrate should be saturated surface dry at the time of Spatter Dash LB application.
Make sure the substrate is suitable for the application of Spatter Dash LB, in case of doubt, try on sample area to assess its suitability. Do not apply the product under direct rain, extreme wind, and at temperatures below +5ºC or above +45ºC.
Spatter Dash LB is highly alkaline therefore avoid direct contact with eyes or skin. It is recommended to use protective gloves and goggles during application. Any skin contact should be washed with soap and water. In case of eyes irritation, immediately wash with copious amount of clean cold water. Seek medical advice.
Spatter Dash LB is non-flammable.
For further information, please refer to material safety data sheet.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
High quality light weight premixed acoustic plaster
High quality light weight gypsum plaster
Thermal insulation llight weight gypsum perlite plaster
Sprayable premixed plaster
Sprayable premixed plaster
Self smoothening epoxy based floor topping from 0.8 to 2 mm thickness