Single component cementitious fairing coat
Vetorep CR523 is a single component polymer modified fibered cementitious fairing coat that is ready to use and only requires the addition of water on site. Once mixed the products becomes a smooth paste that is used to repair surface imperfections up to 3 mm thickness while being compatible with host concrete. Vetorep CR523 is composed of a blend of hydraulic cements, carefully selected and graded aggregates, fibers and special additives to give it its unique properties.
Vetorep CR523 supplied in 25 Kg Bag. Consumption - 18 Liters Yield.
Original sealed bags of Vetorep CR523 has a shelf life of 12 months provided it is stored clear of ground in a dry and shaded temperature controlled place <35ºC.
To ensure proper mixing, a mechanically powered mixer or drill fitted with suitable paddle should be used. However for small quantities, Vetorep CR523 can be hand mixed using proper tools and bucket.
Pour 7.5 - 8.5 liter of fresh water to a clean container then add the powder slowly to the water while mixing continuously with low speed mixer/drill (400 - 600 rpm). Mixing time should be continued for 3 minutes until uniform consistency is obtained.
To enhance the scratch resistance of Vetorep 523, the addition of Vetobond PB434 is advisable. Consult your Saveto representative for further information.
Placing and Finishing
Vetorep CR523 can be applied by steel trowel. The mixed mortar can be applied to the prepared substrates at up to 3 mm thicknesses. The applied mortar should be allowed to stiff en before trowelling to a smooth finish..
Curing is not required for Vetorep CR523 in normal ambient conditions. In the case of harsh weather conditions, such as high wind and temperatures, it is recommended to cure with Vetobond AB432.
All surfaces should be clean, sound and uncontaminated prior to the application of Vetorep CR523. The prepared area should be cleaned thoroughly by brush and/or compressed air. The prepared area should be soaked
with water immediately prior to the application of Vetorep CR523.
Vetorep CR523 Contains reins which may cause sensitization by skin contact. Avoid contact with skin and eyes and inhalation of vapor. Wear suitable protective clothing, gloves and eye/face protection. Barrier creams provide additional skin protection. Should accidental skin contact occur, remove immediately with a resin removing cream, followed by soap and water. Do not use solvent. In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice. If swallowed seek medical attention immediately. Do not induce vomiting.
Vetorep CR523 is non-flammable.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Epoxy resin twin cartridge anchoring grout
Water based concrete curing compound
Resinous, render receiving concrete curing compound
Water based acrylic curing compound and primer
Multipurpose universal cementitious non-shrink grout
Silane acrylate surface treatment, enhancer and hardener for lime stone, concrete, and masonry