Chemical mold and form-work release Concentrate
Vetorel XT421 is a single component, black box concentrate of specially formulated oils and additives that when diluted by 200 liters of diesel oil will produce a low viscosity liquid composed of synthetic mineral oils and special varied additives that performs in a superior manner to standard oil based mold release agents. Vetorel XT421 provides the plywood surface with a water repellent film preventing concrete from adhering to the form work resulting with a smooth, stainless concrete surface.
Vetorel XT422 supplied in 7 Kg. Coverage - 20 - 60 m2/Ltr of diluted product.
Original sealed container of Vetorel XT422 and has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 35ºC.
Pour the entire contents of the Vetorel XT422 concentrate into a 200 liter drum of diesel oil.
Use a drum stirrer or a small circulation pump to mix the contents of the drum.
Vetorel XT422 is supplied in 10 kg pails that need to be mixed and diluted with 200 liters of Diesel prior to use. The mix can then be applied by brush, roller or spraying machine.
Apply the diluted Vetorel XT422 on plywood or steel shutter before the first casting. After every use of form-work, the shutter should be recoated lightly with Vetorel XT422 dilute.
Do not over apply the diluted Vetorel XT422 on the form-work. Excessive material should be allowed to drain before using the form-work.
Apply the product with a brush or preferably with a sprayer. For best results, it is advisable to apply diluted Vetorel XT422 at least two hours before using the shutter.
Consult Saveto technical department for any additional information.
All molds, shutter surfaces must be cleaned from deposits of rust, concrete, oil or other materials. The product is ready to use without any dilution.
Vetorel XT422 is a mixture of mineral oils and additives that do not pose a threat to human health. The product is not suited for injection.
If swallowed seek medical attention immediately - do not induce vomiting.
For further information consult the Material Safety Data sheet available for this product.
Vetorel XT422 has a shelf flash point, so the flammability risk is low. Do not expose to naked flames or other sources of ignition.
Cleaning and disposal
Spillages of Vetorel XT422 should be absorbed onto sand, earth or vermiculite and transferred to suitable containers. Contaminated areas will become slippery.
The disposal of excess or waste material should be carried out in accordance with local legislation under the guidance of the local waste regulatory authority.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
Epoxy resin twin cartridge anchoring grout
Water based concrete curing compound
Resinous, render receiving concrete curing compound
Water based acrylic curing compound and primer
Multipurpose universal cementitious non-shrink grout
Water resistant grout for swimming pool tile joints