Weather resistant premixed cementitious scratch coat
Spatter Dash S is a cement based key coat composed of hydraulic binders, selected sand aggregates and high performance additives. It is supplied as a dry powder in pre-weighed bags ready to use on site, which requires only addition of clean water to produce easily spray-able mortar. Spatter Dash S is a high quality product for multipurpose applications and does not contain additional bonding agent.
Spatter Dash S is available in grey colour.
Spatter Dash S is supplied in 50kg Bags, with coverage: 1.3-1.6 Kg / m2 / mm thickness
Original sealed container of Spatter Dash S has a shelf life of 12 months provided it is stored clear of ground in a dry shaded place below 25ºC.
Add to the mixing container 10-12.5 litres of water foreach 50 Kg bag of Spatter Dash S. Add the powder to the water and mix with a mechanical plaster mixer or low speed electric drill fitted with a suitable paddle for 3-4 minutes, until a uniform, lump-free consistency is achieved.
Manual mixing is allowed for small batch quantities and mix for approx. 1-2 min or when homogenous mix is achieved.
Smooth Concrete Surfaces
For extra adhesion requirment, add 1 litre of Vetonit Bond 2 to the mixing water and adjust the water requirement accordingly for each 50 kg bag. Follow same mixing procedure as described above.
Mixed material can be used within 1 hour.
Do not add water to the mix once the mixed mortar start to harden.
Spatter Dash S preferably be applied in a single coat application to achieved desired thickness of 4-6 mm. Apply mixed material using mechanical spray or manual spatter machine or hawk & trowel technique.Cover 95-100% of surface area to be plastered. Allow the installed application to remain undisturbed for at least 48 hours.
Spatter Dash S is best cured by spraying water on the surfaces of applied materials every 12 hrs for minimum of 3 days. During hot & dry conditions allow curing for minimum of 5 days. It will help to obtain high mechanical strengths and minimize the risk of surface cracks.
Substrate should be sound, clean, free from loose material, grease, laitance, dirt curing compound, etc.Prior to Spatter Dash S application, wet the entire surfaces with clean potable water and surface should look damp at the time of Spatter Dash S application.
Spatter Dash S is highly alkaline therefore avoid direct contact with eyes or skin. It is recommended to use protective gloves and goggles during application. Any skin contact should be wash with soap & water. In case of eyes irritation, immediately wash with copious amount of clean cold water. Seek medical advise.
Spatter Dash S is non-flammable.
For further information, please refer to material safety data sheet.
Saveto endeavors to ensure that any advice, recommendations, information it may give, is accurate and correct. It cannot accept any liability either directly or indirectly arising from the use of its products, because it has no direct or continuous control over where or how its products are applied, whether or not in accordance with any advice, specification, recommendation or information given by us. Saveto has the right to change any of the specifications mentioned in the Technical data sheets upon its discretion without prior notification.
Hard copies of TDSs are printed once or twice a year, while our technical data sheets are continuously being updated as per R&D improvements and new 3rd party testing; kindly refer to our website for the latest updated TDSs.
High quality light weight premixed acoustic plaster
High quality light weight gypsum plaster
Thermal insulation llight weight gypsum perlite plaster
Sprayable premixed plaster
Sprayable premixed plaster
Premixed 4 to 15 mm thick polymer modified cementitious self leveling underlayment.